Spectra Precision Survey Pro v3.80 Recon GPS User Manual User Manual
Page 93
Trouble Shooting
89
o
You set up the rover and the Rx. Light on the rover radio is not
blinking.
¾
Make sure the radio serial cable is connected.
¾
Make sure the radio antenna is connected.
¾
Make sure the rover radio COM port and baud rate is
correct.
¾
Make sure the base and rover radios are on the same
channel.
o
You set up the rover and the Rx. light is blinking sporadically.
¾
The radio is receiving interfering signals on this channel.
Switch the base and rover radios to a different channel.
o
You set up the rover and the Rx. light is blinking but the Data
Link card on the GPS Status screen says
No Data from Radio
.
¾
Make sure the radio serial cable is connected.
¾
Make sure the rover radio COM port and baud rate is
correct.
Projection Solutions
o
You set up a mapping plane requiring data files for datum
conversion or you are using geoid modeling and you get a message
about files not found.
¾
Make sure the required data files are in the directory
specified on the
Path to Data Files
field on the Projection
card of the Job, Settings screen.
o
You select a custom projection file and you get a message about
file format not valid.
¾
The .CS5 or .PJ5 custom projection file has been
corrupted. Open the file in the text editor and repair it or
generate a new file using Survey Link.
o
You solve localization and the horizontal or vertical residuals are
larger than the measurement precision of the instrument, or