WEN 5182 18 Volt Cordless Drill/Drive Kit - Manual (Page 14)

2. Begin drilling at a very low speed to prevent the bit from slipping off the starting point.
3. Maintain a speed and pressure which allows cutting without overheating the bit. Applying
too much pressure will:
-Overheat the drill.
-Wear the bearings.
-Bend or burn bits.
-Produce off-center or irregular-shaped holes.
MASONRY DRILLING
For maximum performance, use carbide-tipped masonry bits when drilling holes in brick, tile,
concrete, etc.
Maintain a speed and pressure which allows cutting without overheating the bit or drill.
Applying too much pressure will:
-Overheat the drill.
-Wear the bearings.
-Bend or burn bits.
-Produce off-center or irregular-shaped holes.
Apply light pressure and medium speed for best results in brick.
Apply additional pressure for hard materials such as concrete.
When drilling holes in tile, practice on a scrap piece to determine the best speed and pressure.
Begin drill
ING! Always wear safety goggles or safety glasses with side shields during
ARNING! To ensure safety and reliability, all repairs should be performed by a
ing at a very low speed to prevent the bit from slipping off the starting point.
WARN
power tool operation or when blowing dust. If operation is dusty, also wear a dust
mask.
W
qualified service technician at Authorized Service Center.
14