Aposonic A-S3216T3 - Manual (Page 16)

DVR User Manual
10
Item Name Function
9 Direction Button Move cursor in setup or pan/tilt PTZ
10 +/- Button To increase or decrease the value in setup
11 Playback Control Button To control playback, Fast forward/rewind/stop/single frame play
12 AUDIO Button To enable audio output in live mode
13 Auto Dwell Button To enter into auto dwell mode
14 BACKUP Button To enter into backup mode
15 PTZ Control Button To control PTZ camera: Move camera/zoom/focus/iris/speed control
Note: Key points to check in case the remote doesn‟t work.
1. Check batteries polarity.
2. Check the remaining charge in the batteries.
3. Check IR controller sensor for any masking.
4. Check the ID of the remote with respect to the DVR.
If it still doesn't work, please try using a good known remote, or contact your dealer.
The interface of remote controller is shown in Fig2.6 Remote Controller.
Operation processes with remote controller to control multi-DVR
The default device ID of the DVR
is 0. It‟s not necessary to reset the device ID when a remote is to be used to control a single
DVR. However when controlling multiple DVRs with multiple remote controllers, you would need to configure the device ID,
please refer to below steps:

Activate remote controller to control the DVR: Turn the IR sensor of the remote controller towards the IR receiver on the front
panel, press the number key 8 twice on the remote, then input device ID of the DVR to be controlled (Range from: 0-65535;
the default device ID is 0) and press ENTER to confirm.