Appendix b: sensiscan 2000, Mounting in cab-a3f or cab-b3f cabinet – Fire-Lite APS-6RF Auxiliary Power Supply User Manual
Page 19
APS-6RF Instruction PN 50893:B 7/20/00
19
Appendix B: Sensiscan 2000
Mounting in CAB-A3F or CAB-B3F Cabinet
This section contains instructions for the installation of the Auxiliary
Power Supply onto a CHS-4F chassis used in a CAB-A3F or CAB-B3F
cabinet.
To mount the APS-6RF, follow these instructions:
Figure 11 Mounting an APS-6RF to a CHS-4F Chassis
Step
Action
1
Remove plastic cover from APS-6RF.
2
If 240 VAC is to be used, cut JP1 jumper at this time. See "Configuring the
APS-6RF" on page 15.
3
Place the APS-6RF onto the mounting studs of the chassis.
4
Insert a standoff through each of the printed circuit board mounting holes,
threading each standoff to the mounting studs on the chassis.
5
Tighten the standoffs until the APS-6RF is securely fastened to the chassis.
6
Reinstall the plastic chassis cover.
CHS-4F Chassis
Standoff
(2 places)
APS-6RF
Assembly
A
PS-
6
R
t
o
C
H
S-
4
.c
d
r