Fire-Lite LCD-80F Remote LCD Annunciator User Manual
Page 12
LCD-80F Annunciator
SW1 DIP Switch Settings
12
Document 51338 Rev. B 08/24/05 P/N 51338:B
4 through 6 = Configuration for use with a particular FACP.
Switches 4, 5 and 6 are used to select the FACP (Fire Alarm Control
Panel) which is being connected to the LCD-80F. Refer to the
following table for the appropriate switch settings.
Programming Note: Depending on the FACP which is connected to
the LCD-80F, it may be necessary to enable communication with the
annunciator in the FACP programming. Refer to the appropriate
FACP manual for programming information.
7 and 8 = Future use.
Fire Alarm Control Panel
SW1-4
SW1-5
SW1-6
Use This Setting
OFF
OFF
OFF
Future Use
OFF
OFF
ON
Future Use
OFF
ON
OFF
Future Use
OFF
ON
ON
Future Use
ON
ON
OFF
Future Use
ON
OFF
ON
Future Use
ON
ON
OFF
Future Use
ON
ON
ON