Fire-Lite PRN-6 Operators Manual - Manual (Page 16)

Changing the
paper type You can change the paper type (the paper path) either using the paper path quick selection feature
or via the Setup menu.
➤ Paper path quick
selection First cut the fed-out portion of a Continuous Form Feed Paper at the perforated line. To do this,
proceed as follows.
Make sure that the printer is in Offline status; press the Online key, if necessary.
Press the Park key.
If fanfold paper is in the printer, it is transported to the tear position. “Tear paper
off” appears on the display. Press any key.
If a single sheet is loaded in the printer, it is ejected.
Select the desired paper path by pressing one of the I keys, in our example Single .
The printer returns to Offline mode.
The display toggles between…
and…
Set the Paper Type Selection Lever to Cut Sheet Paper mode (see page 11 Loading
paper).
The display toggles between…
and…
Stand the Paper Tray up in the direction indicated by the arrow. While holding
the Paper Tray, pull up the Paper Extension Trays.
Determine the left margin by moving the Left Paper Guide left or right.
Place a sheet of paper aligned to the Left Paper Guide, and adjust the Right Paper
Guide to the right edge of the paper. Insert the paper between the Left and Right
Paper Guides. The paper is automatically fed to the print start position (see page 11
Loading paper).
Setup
Online
Offline Trac.1
Park Load
Setup
Online
Single Trac.1
Park
Setup
Online
Offline Single
Setup
Online
Turn paperlever
Setup
Online
Load paper from
Single
Park
Setup
Online Offline Single
If you do not make a selection within 5 seconds, the printer exits
the menu.
Changing the paper type Quick start-up
14