Fire-Lite PRN-6 Operators Manual User Manual
Page 21
➤
Changing paper in
Setup mode
➤
From fanfold paper
to single sheet mode
When fanfold paper was in use and you want to change over to single sheet mode, proceed as
described below.
You do not need to remove the fanfold paper.
Cut the fed-out portion of the Continuous Form Feed Paper at the perforated line.
To do this, proceed as follows.
Press the
Setup
key. The printer changes to Setup mode.
Press the
Paperway
key. The printer changes to the paper path menu.
Press
<
or
>
to change to
Single
(sheet) operating mode.
The currently valid setting (
Tractor 1
) is marked by a “
*
”.
Confirm the setting by pressing the
Set
key.
The input is acknowledged by an acoustic signal and the fanfold paper is trans-
ported to the tear position. Cut the fed-out portion of the Continuous Form Feed
Paper at the perforated line.
In the display appears…
Press any key.
The printer returns to its initial status and the fanfold paper is transported to the
park position.
The display toggles between…
and…
Setup
Online
Online
Trac.1
Load
Setup
Online
Adjust
Paperway
Menu
Char
Setup
Online
Tractor 1
*
Set
Exit
Setup
Online
Single
Set
Exit
Setup
Online
Tear paper off
Press any key
Park
Load
Setup
Online
Offline
Single
ENGLISH
Quick start-up
Settings (II)
19