Caution – HT instruments M71 User Manual

Page 4

Advertising
background image

M71

EN – 3

1.1. PRELIMINARY

INSTRUCTIONS

• This instrument has been designed for use in environments with pollution degree

• It can be used for voltage and current measurements on electrical installations with

CAT III 240V to earth and maximum voltage of 415V between inputs

• The instrument can be used on electrical installations type TT, TN and IT industrial,

civil, medical, zoo-technical both under ordinary conditions where contact voltage limit
is 50V, and under special conditions where contact voltage limit is 25V

• You are recommended to respect the usual safety regulations aimed at protecting you

against dangerous currents and protecting the instrument against improper use

• Only the original accessories supplied along with the instrument guarantee compliance

with the safety standards in force. They must be in a good conditions and, if necessary,
replaced with identical ones

• Do not test nor connect to any circuit exceeding the specified overload protection

• Do not take measurements under environmental conditions exceeding the limits

indicated in this manual

• Make sure that batteries are correctly installed.

1.2. DURING

USE

You are recommended to read carefully the following instructions::

CAUTION

Failure to comply with warnings and instructions may damage the instrument
and/or its components as well as injure the operator.

• When the instrument is connected to circuits never touch any unused terminal

• Do not measure in the presence of external voltages. Although the instrument is

protected, an excessive voltage may cause malfunction

• Avoid submitting the instrument to voltage while measuring (i.e. a test lead slipping off

the measuring point accidentally touching an energized point).

CAUTION

If the “low battery” symbol

is displayed during use interrupt testing, switch

off the instrument and replace batteries following the procedure described in
§ 5.2.


1.3. AFTER

USE

• Turn off the instrument pressing ON/OFF key after using it

• If you expect not to use the instrument for a long time remove batteries.

Advertising