HT instruments T2100 - Manual (Page 17)

T2000-T2100
EN – 16
4.6. CURRENT MEASUREMENT (T2000)
CAUTION
Do not measure AC current values exceeding
20A in order to prevent possible
electrical shocks and any damage to the instrument.
Fig. 20: AC current measurement
1. Press and hold the multifunction key “
1” for more than 2 seconds to switch on the
instrument.
2. The instrument displays the message “ OL ”
as it automatically sets for resistance
measurement. Shortly press the multifunction
key “
1” to enter current measuring mode. The
screen in Fig. 21 is displayed
3. Open the jaws and clamp the cable to be
measured (see Fig. 20), then read the
displayed result Fig. 21
4.6.1. HOLD
Shortly pressing the multifunction key “
3”
activates the “
HOLD” function and freezes the
result on the display (see Fig. 22). To go back to
the normal measuring mode, shortly press the
multifunction key “
3” again or shortly press the
multifunction key “ 1” (ESC function).
Fig. 22