HT instruments T2100 - Manual (Page 24)

T2000-T2100
EN – 23
4.10. RS232 COMMUNICATION WITH A MASTER INSTRUMENT (T2100)
CAUTION
The clamp has a RS232 half-duplex serial output and, therefore,
it can ONLY
be connected to suitable HT instruments. Do not connect the clamp’s serial
output to other equipment as this may cause damage to the clamp itself.
Fig. 40: Connecting T2100 to a MASTER instrument
The clamp T2100 allows the following operations:
 Transmission in real time of the measured value to the MASTER instrument
 Transmission to the MASTER instrument of all the measured values contained in the
memory
Procedure
1. Press and hold the multifunction key “
1” for more than 2s to switch on the instrument.
2. Press the multifunction key “ 1” until you see the symbol
3. Connect the clamp to the MASTER instrument with the cable.
4. Follow the instructions contained in the manual of the MASTER instrument in order to:
 Display the measured resistance value on the MASTER instrument’s LCD
 Transfer all the measured values stored in the clamp T2100’s memory to the
MASTER instrument