In-Situ Con TROLL PRO Installation Manual (purchased before 10 May 2012) - Manual (Page 14)

14 Mounting the Controller
3.2.5 DIN Rail Mounting the Enclosure
Each rail mount clip is secured to the enclosure with a supplied #6 screw.
1. With the enclosure open, drop one screw into each drilled corner of the box
(Figure 13).
2. Use a long screwdriver to push the screw through the back of the enclosure
(Figure 13).
3. Place the DIN clip on the top of the enclosure with the orientation shown in
Figure 14.
4. Use a long screwdriver to tighten the screw to the clip.
5. Repeat steps 2-4 for the remaining screw and clip.
6. Mount on a DIN rail.
FIGURE 13. Placing the screw in the enclosure
FIGURE 14. Securing the screw to the DIN clip
3.3 PLACING DOME CONNECTORS AND PLUGS IN THE ENCLOSURE
When installed as directed, this product is rated IP-67 and can withstand
temporary immersion in up to 1 meter of water. To meet the IP-67 rating, the
following conditions must be met:
• The lid must be completely closed and screwed down.
• The six ports must be plugged with either cord grips and cables, port
plugs, or a combination of the two.
• Additionally, o-rings must be used as described below.
Attach plugs and dome connectors to the enclosure using the following
steps:
1. Place a large o-ring over the threaded end of the plug or dome connector
(Figure 15).
2. Screw the threaded end of the plug or dome connector through the bottom of
the enclosure. Tighten it to “snug” and then an additional ½ turn. Do not
overtighten!
3. Inside the enclosure, place the lock nut, concave-side-down, over the threaded
end of the plug or dome connector and tighten with a flat-head screwdriver and
mallet (Figure 16). Tighten the lock nuts so that there is approximately one
thread showing above the nut.
4. Screw the dome nut onto the threaded connector. Tighten it to “snug” and then
an additional ½ turn. Do not overtighten!
Top of enclosure
DIN clip
Screw, #6