KANOMAX 2211 Handheld IAQ Monitor User Manual
Page 13
8
<Compensation>
when atmospheric pressure of the place to measure is different from normal atmospheric pressure
(such as high altitude), Please follow below steps for Atmospheric pressure setting (Initial value:
1013hPa).
Since the change of weather does not significantly affect the atmospheric pressure as long as the
place to measure is same (Exclude the case of typhoon), you need to set Atmospheric Pressure only
1 time.
Display
Procedure
Press
.
Use
to select [7.CALIBRATION] .
press
.
Use
to select [3. ATMOS. PRESS SET]
press
.
Use
to set Atmospheric Pressure value.
Press
.
Use
to select Select [4. SAVE INFO.].
Press
.
※
This will complete the setting and you are back in Main Menu.
2.5.2 Measuring Temperature and Attentions
Responsiveness of the temperature measurement is proportional to the speed of airflow. We
recommend for you to use the displayed value when reading becomes stabilized.
With no airflow is present, temperature reading value may be slightly higher than actual temperature
due to the heat generated by this sensor. For accurate temperature reading, we recommend for you
to use at least 0.1m/s of airflow.