ADTRAN ATLAS 810 Plus - Manual (Page 118)

Chapter 9. Dial Plan Terminal Menu
9-24 ATLAS 810 PLUS User Manual 61200266L1-1
The following Step/Action Tables and numbered tables provide informa-
tion on setting up Example 3.
Instructions for Configuring the Ports for Example 3
Step Action
1
Prior to setting up the Dial Plan, you must configure the Controller
T1/PRI interfaces.
2
This configuration action only brings up the T1 transport; set the
BRI configuration (SPID and phone number) as part of the Dial
Plan.
Instructions for Setting Up the Dial Plan for Example 3
Step Action
1
Determine the network and the attached equipment (video
equipment and PBX) provisioning (see Table 9-1).
2
From Dial Plan, select Global Parameter, and enter the local area
code (needed for Caller ID operation).
3
Determine which ports are Network terminations and which are
User terminations.
4
Define the phone number acceptance and rejection criteria for
each termination.
Example 3 includes one PRI port terminating the network
(PRI-A) and three BRIs (BRI A, B, and C)—see Table 9-2.
User terminations include one PRI, one RBS T1, and three BRIs
(see Table 9-3).