ADTRAN ATLAS 810 Plus - Manual (Page 120)

Chapter 9. Dial Plan Terminal Menu
9-26 ATLAS 810 PLUS User Manual 61200266L1-1
To implement the Dial Plan for Example 3, navigate to Dial Plan/Global
Param and set the global parameters for PRI A, B, and C. Then, navigate to
User Term and set the connections for PRI D, E, and F. The following Step/
Action tables provide step-by-step instructions for completing these proce-
dures.
Table 9-3. User Terminations
NAME PORT INCOMING
ACCEPT #
OUTGOING
REJECT #
OTHER
BRI-D
BRI-E
BRI-F Octal BRI
Slot 1,
Ports 4-5,6 888-1001 (D);
888-1002 (E);
888-1003 (F) Blank - No called
number will be
rejected. BRI type:
5ESS SPID # to match Video
Equipment provisioning.
Phone #s:
888-1001 (D); 888-1002 (E);
888-1003 (F)
Phone numbers must match
phone numbers provisioned
in video equipment.
PRI-B Controller T1
Slot 0,
Port 2 888-1010
This forms a hunt
group. Blank - No called
number will be
rejected. PRI type:
5ESS
Must match RAS equipment.
DID=none
T1-A Slot 2,
Port 1 821-8XXX
This accepts all calls
beginning with
821-8. 1-900-$
This rejects all calls
beginning with
1-900. RBS 1st DS0=1;
#DS0 = 24
Signalling = E&M wink
DID = Enable/# of digits = 4
Setting PRI A Global Param
Step Action
1 Navigate to Dial Plan (in the terminal menu).
2
Enter the area code by selecting Global Param/Area Code and
pressing Enter. Input the area code, and press Enter again.
3
Define the interface type as PRI by selecting Network Term and
entering the following settings: Slot = 0, Port = 1, Sig = PRI.
4
Tell ATLAS to forward any call to the network by selecting
Out#Accept and entering $ in the number field. Leave all other
selections set to default (Enabled).
5 Ensure Out#Reject contains no entry.
6 Set the PRI switch type to National ISDN (from Ifce Config).