Aiphone AXW-AVR - Manual (Page 11)

CONFIGURATION DIAGRAM:
AXW-AVT with Axis 243SA Video Server (Standalone Only)
Configuration Notes:
1. AX-series video door station connects to ‘DOOR’ input of AXW-AVT.
Ensure that the “CCTV / DOOR’ switch on the AXW-AVT is in the ‘DOOR’
position.
*2. Alternatively, an IE/IF-series or AX-DM audio door may be used, along
with 3 rd party CCTV camera. Connect audio door station to ‘Door’ input
(following the wiring method shown in the AX-series installation manual,
pg. 12). Connect the camera to ‘Video In’ and put the ‘CCTV / DOOR’
switch in the ‘CCTV’ position.
3. Connect the Call In / Call Out and Audio In / Audio Out connections on
the AXW-AVT to the Axis 243SA connectors, as shown.
4. Configure AXW-AVT internal jumpers as necessary (see Pg. 21).
Pg. 19 Pg. 20
Please Note:
Only information pertaining to the connection and operation of the AXW-AVT / AXW-AVR and listed 3
rd party devices interfacing with it are included here. Aiphone is not
responsible for attempts to connect the AXW-AVT / AXW-AVR to untested 3 rd party transmission hardware. Consult the installation manual for the 3 rd party device being utilized
for further information regarding physical mounting, base functionality, power requirements, etc. For the most up-to-date compatibility information, please consult http://
www.aiphone.com or contact Aiphone Technical Support.
For complete AX system installation, wiring, and programming information, please consult the AX Installation Manual (included on CD with AX Central Exchange Unit, or
available at http://www.aiphone.com).
CCTV Camera
75 Ohm, 1V Peak-to-peak
(Independently powered)
Normally Closed input for remote activation
(i.e. motion sensor, loop detector, etc.)
Normally Open contact for remote device activation
(i.e. video switcher, DVR, etc.)
AXW-AVT
24V
+
-
RELAY
NO
NO
SENSOR
NC
NC
CALL IN
+
-
CALL OUT
+
-
AUDIO IN
+
-
AUDIO OUT
+
-
DOOR
VIDEO IN
VIDEO OUT
AX-DV
AX-DM or IE/IF-Series
Audio Door Station
CAT-5e
Coax
*
+
-
PS-2420UL
Axis 243SA
(Front View)
Coaxial Video Cable
Axis 243SA
(Back View)
To Network
Axis 243SA Application Considerations:
The Axis 243SA can only be used in ‘Standalone’ configuration (i.e.,
utilizing a PC as a master station).
When used in standalone configuration, Aiphone recommends
Controlware’s VIPDoorControl software. For further details, see
http://www.vipdoorcontrol.com.
Consult the Axis 243SA Installation and User manuals for further
information pertaining to video server installation and configuration.
NETWORK POWER
STATUS
75Ω ON
1 2 3 4
AXIS 243SA
Video Server
VIDEO
IN OUT
LINE
OUT
LINE/MIC
IN
NETWORK RS-232
POWER 1 2 3 4 5 6 7 8 9 10 11 12
To Axis-supplied
power source