Aiphone AXW-AVR - Manual (Page 6)

CONFIGURATION DIAGRAM:
AXW-AVT / AXW-AVR with Infinova Fiber (N3732TA-M/-R, N3732RA-M/-R), 2 of 2
Pg. 9 Pg. 10
CEU
AUDIO IN
+
-
AUDIO OUT
+
-
CALL IN
+
-
CALL OUT
+
-
RELAY
NO
NO
VIDEO IN
VIDEO OUT
AXW-AVR
To AX-CEU
(Door Input)
Coaxial Video Cable
Normally Open contact for remote device activation
(i.e. video switcher, DVR, etc.)
Composite Video Output
(for CCTV monitor, DVR, etc.)
Configuration Notes (2 of 2):
1. Connect the AXW-AVR ‘CEU’ connection to an unused Door station input on the AX-CEU and ensure that the
AX-CEU has been programmed to accept a video door station on that input (see Pg. 2).
2. Connect the Call In / Call Out and Audio In / Audio Out connections on the AXW-AVR to the terminal block of the
Infinova N3732RA-M, as shown. For detailed terminal definitions, consult the Infinova installation document.
3. Per the Infinova installation manual, set JP11 and JP21 for “600-Ohm, Balanced” audio connection.
Application Consideratison:
**If the Infinova fiber modules relay is to be used for door release, the
‘Call Out’ connection on the AXW-AVR will not be used. Instead,
connect pins 15/16 from the fiber module to the appropriate door release
output on the AX-CEU. Be sure to short together the ‘Call Out’
terminations on the AXW-AVT, as noted on Pg. 8-9.
Power supply connections to the Infinova fiber modules are not shown,
and are dictated by the mounting method chosen (standalone, rack
mount, etc.). Contact Infinova for available options.
AXW-AVT / AXW-AVR should be mounted as close as possible to their
corresponding Infinova fiber modules. Avoid mounting units near high
voltage AC devices, or other sources of inductive noise.
Infinova
N3732RA-M
PWR
V
OP
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Please Note:
Only information pertaining to the connection and operation of the AXW-AVT / AXW-AVR and listed 3
rd party devices interfacing with it are included here. Aiphone is not
responsible for attempts to connect the AXW-AVT / AXW-AVR to untested 3 rd party transmission hardware. Consult the installation manual for the 3 rd party device being utilized
for further information regarding physical mounting, base functionality, power requirements, etc. For the most up-to-date compatibility information, please consult http://
www.aiphone.com or contact Aiphone Technical Support.
For complete AX system installation, wiring, and programming information, please consult the AX Installation Manual (included on CD with AX Central Exchange Unit, or
available at http://www.aiphone.com).
Optic Fiber
(to N3732TA-M, Pg. 8)
4. The RELAY output on the AXW-AVR
provides a Normally Open dry contact
output whenever the door station
connection is active. This can be used
to activate any device local to the
AXW-AVT (DVR trigger, video switcher
activation, local call indication, etc.).
**