Alpine CDA-7969R - Manual (Page 24)

22
-EN
Searching for Titled Discs/CD Text
If a CD is titled, you can do a search for it. You
can also search for CD TEXT discs by title. (To
title CDs, refer to "Titling Discs" on page 20.)
1
Press and hold the T.S.M. button for at least 2
seconds. The title blinks in the display.
2
Press the DN g or f UP button to select
the desired disc title/CD Text disc.
3
Press the T.S.M. button to play the selected disc.
The unit will automatically search for the disc
and begin play.
NOTES
• This function cannot be performed when using a multi-
changer switching device.
• To search for a title from CD TEXT discs, first you
need to playback the CD TEXT disc at least once so
that it is registered in the unit’s memory.
Multi-Changer Selection
Alpine's Ai-NET system will support up to 6 CD
Changers. When operating two or more changers,
the KCA-400C (Multi-Changer Switching device)
must be used. If you use 1 Switching device, you
can connect up to 4 CD Changers. If you use 2
Switching devices, you can connect up to 6 CD
Changers.
1
Press the SOURCE button on the CDA-7969R to
activate the CD Changer mode.
Alternatively, press the SOURCE button on the
Remote Control (RUE-4185) to activate the CD
Changer mode. Proceed to Step 3 below to
select the desired CD Changer.
2
Press the BAND button on the CDA-7969R or
the RUE-4185 to activate the Changer Selection
mode.
3
The CD Changer Selection mode remains active
for 3 seconds after Step 2 is performed. Press
the BAND button until the desired CD Changer
indicator appears on the display.
NOTE
If the selected CD Changer is not connected, the display
will show "NO CHANGER."
Alternatively press the BAND button on the
Remote Control until the desired changer
indicator appears on the display.
4
To operate the selected changer, see "CD
Operation" section.
CD Player Operation
REMOTE CONTROL UNIT RUE-4185
CD-CHG
SOURCE A.PROC
BAND
PROG
BAND SOURCE
DN g f UP
SOURCE BAND/T.S.M.