KYORITSU 5410 - Manual (Page 4)

DANGER
● This instrument is designed to measure the earth-to-line voltage
90 ~ 264V and the line-to-line voltage up to 440V (50/60Hz). Do not
exceed the maximum allowable input of any measuring range.
● Do not attempt to make measurement in the presence of
flammable gasses. Otherwise, the use of the instrument may cause
sparking, which can lead to an explosion.
● Keep your fingers behind the safety barrier on the test leads.
● Set the Function Switch to any desirable Range before making
a measurement. Do not power on the instrument with it being
connected to the live circuit
.
● Never attempt to use the instrument if its surface or your hand are
wet.
● Never open the Battery Cover during a measurement.
● Verify proper operation on a known source before use or taking
action as a result of the indication.
WARNING
● Never attempt to make any measurement if any abnormal
conditions, such as a broken cover or exposed metal parts are
present on the Instrument and test leads.
● Do not install substitute parts or make any modification to the
instrument. Return the instrument to your local KYORITSU
distributor for repair or re-calibration in case of suspected faulty
operation.
● Set the Function Switch to the OFF position when removing the
Battery Cover for battery replacement.
● If the overheat symbol “ ” appears on the display, disconnect the
instrument from the measuring point and allow to cool down.
CAUTION
● Firmly insert the plugs of test leads to the appropriate terminals.
● Set the Function switch to the OFF position after use, and remove
the batteries if the instrument is to be stored and will not be in use
for a long period.
● Use a damp cloth with neutral detergent for cleaning the instrument.
Do not use abrasives or solvents.
● Do not store the instrument if it is wet.
2