KYORITSU 6017 - Manual (Page 13)

11
5-4 Battery Voltage Check
1. Set the function selector switch to the BATT CHECK position.
2. Press the test button or the remote control switch.
3. If the meter pointer does not reach the "BATT GOOD" area, replace the
batteries as shown in section 5-1 "Installing Batteries."
CAUTION
¡ Do not keep the test button pressed or locked down during battery check
to avoid battery power drain.
5-5 "Power-on" Indication LED
On an insulation resistance, an earth resistance or the BATT CHECK range, when
the test button or remote control switch is pressed, the power-on-indication LED
(red) lights up, indicating the instrument is in the operation mode. The "power-on"
indication LED also lights up on the earth voltage range since a relay incorporated
in the instrument is activated.
CAUTION
¡ In order to conserve battery power, turn the function selector switch back
to the OFF position after measurement. Otherwise, the instrument
remains in the stand-by mode and consumes battery power. Particularly
on the earth voltage range, current consumption is as high as 50mA.
Proceed to measurement.
Batteries have exhausted.
Replace the batteries.