KYORITSU 6017 - Manual (Page 17)

15
1. Set the function selector switch to AC600V. Connect the earth probe (alligator
clip on black lead) to earth of the circuit under test and the line probe (red) to
the other side as shown below. If the circuit is not earthed, connect the earth
probe to an appropriate conductor.
2. Do not press the test button or the remote control switch. Take the reading on
the AC voltage scale.
3. Set the function selector switch to the OFF position.
Note:
¡
The "OK" lamp does not light up in AC voltage measurement.
注意：測定スイッチは
押さない
注意：リモートスイッチは
押さない
Note: Do not press the remote
control switch
Note: Do not press the test
button.