Spectrex 40/40M Multi IR Flame Detector - Manual (Page 57)

TM 40/40M, Rev (6) July 2013
Troubleshooting 45
 Option 2: Power, RS-485, 0-20mA (Source) and
HART protocol, Fault Relay (N.O), Alarm Relay, (N.O),
(N.C).
 Option 3: Power, RS-485, 0-20mA (Source) and
HART protocol, Fault Relay (N.O), Alarm Relay (N.O,
N.C).
 Option 4: Power, RS-485, Fault Relay (N.C), Auxiliary
Relay (N.O), Alarm Relay, (N.O).
 Option 5: Power, RS-485, Fault Relay (N.O),
Auxiliary Relay (N.O), Alarm Relay, (N.O).
Electrical
Outputs  Dry Contact Relays
Table 22: Contact Ratings
Relay
Name Type Normal
Position Maximum
Ratings
Alarm SPDT N.O., N.C. 2A at 30 VDC
Auxiliary SPST N.O. 2A at 30 VDC
Fault
(see Notes
1 and 2)
SPST N.C. or
N.O 2A at 30 VDC
Notes:
1.
The Fault relay (in wiring options 1, 2, 4) is
normally energized closed during normal operation
of the detector. The relay is de-energized open if a
fault condition or low voltage situation occurs.
2. In wiring options 3, 5 the relay is normally
energized open during normal operation of the
detector. The relay is de-energized close contact if
a fault condition or low voltage situation.
 0-20mA Current Output: The 0-20mA can be Sink
or Source according to the wiring option source (see
General Instructions for Electrical Wiring on page 49).
The maximum permitted load resistance is 600Ω.
Table 23: 20 mA Current Output
State Output
Fault 0 +1 mA
BIT Fault 2 mA±10%
Normal 4 mA±10%
Warning 16 mA±5%
Alarm 20 mA±5%
 HART Protocol
The HART protocol is a digital communication signal at
a low level on top of the 0-20mA. This is a bi-
directional field communication protocol used to