Techne TC-4000 - Manual (Page 43)

41
Program defaults
Settings
There are a number of options which can be
changed; these are listed here.
Use the "Up Arrow" and "Down Arrow"
keys to select then press "Enter" to access
any of the options. Each option is discussed in
detail below.
Highlight 'Program defaults' then press
"Enter"
The complete list of program defaults is given
here. These are the values that all new
programs will have when you start to create a
new program.
To edit any line use the "Up Arrow" or
"Down Arrow" keys to select the line
you wish to change.
Press "Enter" then change the value using
the numerical keys. Press "Enter" to accept
the new value.
To edit a field with on/off settings, first select
the field and press "Enter"
Use the "Up Arrow" and "Down Arrow"
keys to toggle between the settings. Press
"Enter" to accept.
When you have set all the defaults, press the
"Enter" key to go back to the
Configuration menu.
Note: altering the default values does not
change existing programs.
Highlight 'Settings' then press "Enter"
Program defaults
Settings
Passwords
Controller reset
Program defaults
Settings
Passwords
Controller reset
Program defaults
Settings
Passwords
Controller reset
Heated Lid 105°C
Preheat Lid off
Pause off
-------------------------
In denat 94°C 5m00
Hot Start off
-------------------------
Final Extn 72.0°C 5m00
Final hold 10.0°C
-------------------------
Lid type grey
[ , to edit ]