Techne Prime Elite - Manual (Page 21)

19
Installation
1. Place the unit on a suitable flat bench, ensuring that the air inlet vents on the front and rear are
free from obstruction. Two units may be stacked one on top of the other (Prime Elite on a Satellite
or Satellite on Satellite).
2. Plug the mains cable into the socket on the back of the instrument.
3. Connect to the mains electricity supply with the plug provided or one wired correctly for the
supply. Switch the power ON using the switch located on the front of the unit. The front display will
then light up.
4. Open the drawer by pushing on the front drawer panel then pull the drawer forwards to access the
block.
5. Place the samples in the block. If individual tubes or strip tubes are being used, space these out
evenly across the block to equalise the pressure from the heated lid.
6. To close the drawer, push back into the unit until it locks in place.
Connecting Satellite units to the Prime Elite
The Prime Elite has three USB ports on the rear of the unit for connection of Satellite units. Three
Satellite units can be connected directly to the Prime Elite as shown in the configuration below.
USB memory stick