Time Electronics 1077 Milliamp Transducer Simulator - Manual (Page 13)

13
1077 Technical Manual P a g e | 13
4.9. Recharging
To charge the 1077 first turn off the 1077 then connect the charge to the recharge socket on
the end of the 1077. (The connector is polarized to prevent accidental reversal).
Plug charger into mains supply.
If the 1077 is left ON when recharging the cells will not fully recharge.
The 1077 contains Nickel Metal Hydride batteries which are monitored by the battery level
indicator at the end of the unit. The unit will take approximately 12-14 hours to fully recharge
the batteries. The 1077 may be left on charge continuously without damaging the batteries.
Important:
Always recharge when the battery level indicator shows minimum.