West Control Solutions N4400 - Manual (Page 13)

3.6 ABORTING A PROGRAM
The operator may abort (i.e. terminate) the current program by holding down the Run/Hold
key for more than five seconds. When the program is aborted, a return is made to the Base
Mode and the Message Display will show:
This message will be removed by the next keypress.
3.7 “END OF PROGRAM” INDICATION
When the program has reached its End Marker, the Message Display shows:
and a return is made to Base Mode.
3.8 VIEWING PROGRAM AND CONTROLLER PARAMETERS
In Program Run Mode (i.e. with a program currently running or held), the MODE key gives
“view only” access to Program Define Mode and Controller Define Mode:
59215-3 Page 3-3
59215