Audient ASP8024 Dual Layer Control Module - Manual (Page 33)

Page -33- © Audient Ltd
Control Surface Functions
Aux Mode + Assign
When in aux mode, pressing the assign
key (30) provides access to several useful
aux send parameters, however it should be
noted that in the release version of the
ASP2802 firmware, aux sends cannot be
instantiated from the control surface.
Aux sends must be setup in software
using the mouse.
To edit existing send parameters press the assign key (30).
Here you will find access to level readout in dB, FX send on / off
switching and pre / post switching.
There are 8 pages available so that you can access this finer
level of control for all 8 aux sends.
Rotate the encoders to change level, press on them to toggle
between send on / off and pre / post fader settings.