Audient ASP8024 Dual Layer Control Module - Manual (Page 5)

Page -5- © Audient Ltd
Automation Setup
Assuming that you have followed all steps outlined in the main
manual networking section for Apple Mac or PC (page 84
onwards), you will have connected ASP2802 to your studio
computer and connected to the console via
AuNet.
To set up the 8-channel fader automation system in Cubase /
Nuendo, we must use 8 MIDI tracks and place them at the start
or end of your session (we recommend the start so you can add
tracks afterwards with ease as your session progresses).
Please follow the steps outlined below:
Boot Cubase / Nuendo
Create a new session or open an
existing one
Step 1 : Assuming that the MIDI drivers have been detected
(which they should have) - Cubase / Nuendo will immediately
spot the available MIDI ports for ASP2802.
Check this by navigating to the Devices > Device Setup > MIDI
Ports... and verify that the ASP2802 Automation and Control
Surface ports show up as detected for both inputs and outputs.
Please note that inputs will
be indicated as active,
however until you create a
MIDI track that addresses
the ASP2802
automation
output, the
output will
be shown
as inactive.