Audient ASP8024 Dual Layer Control Module - Manual (Page 32)

Page -32- © Audient Ltd
Group Mode
To access Logic’s internal grouping function press the
group mode switch (22) in the select panel.
If this is your first group to be created in Logic, pressing
a
channel select switch (18) to add a channel to the first
group will bring up the Logic group settings dialogue box.
Here you can set
parameters for
the group (via
the mouse) such
as linking record
enable state or
channel strip
colour etc.
Please note that
after the first
group is created,
creating new
groups (>1) must
be done via the
mouse within
Logic.
This is due to the limitation of the HUI TM protocol.
We suggest that you create the groups manually
within Logic as you organise your session for the
start of tracking / mixing etc. Therefore it is
possible to use the ASP2802 control surface to
add / remove channels from all existing groups
using the
page switches (26) to select the group
number and the channel select switches (18) to
enter or exit the current group.
Control Surface Functions