Audient ASP8024 Dual Layer Control Module - Manual (Page 5)

Page -5- © Audient Ltd
Automation Setup
Assuming that you have followed all steps outlined in the main
manual networking section for Apple Mac (page 84 onwards),
you will have connected ASP2802 to your studio computer and
connected to the console via
AuNet.
To set up the 8-channel fader automation system in Logic,
we must assign a HUI
TM controller to a set of ‘dummy’ audio
channels (that contain no session audio - blank) and place them
at the start or end of your session (we recommend the start so
you can add tracks afterwards with ease as your session
progresses). Please note that both
fader position and mute status is
automatable, therefore you could use
the silent muting system to reduce any
noise floor from your vintage outboard
gear during quiet sections.
After booting Logic please follow the steps outlined below:
Step 1 : Logic Pro > Preferences > Control Surfaces > Setup...
Mackie HUI™ (Human User Interface) is a registered trademark of LOUD Technologies Inc.