FUTEK IPM52x (D520) Digital Display - Manual (Page 30)

29
7. DEFAULT program
This program is used for any of the following:
• Reset the meter back to the factory defaults.
• Set the user defined defaults into memory
• Reset the meter to the user defined defaults
"DEFAUL" default program prompt
"YES"/"NO" "NO" to exit this menu
"YES" if one of the 3 defaults is to be done.
Continue to next step
"USER"/"FAC"
• "FAC" (factory) allows the reset of the meter back
to factory defaults. When the prompt
a) "FACTORY" is displayed, the SELECT key
must be pushed and held (10 seconds) until
the prompt "DONE” and returns to "SPEC"
branch. If any other key is push it will abort
the default operation and return to "SPEC"
branch.
• "USR" (User) allows the setup of custom defaults
or default to the custom defaults
b) "STORE" allows the custom defaults to be
set. This will set the defaults to the setup of
the meter it is currently programmed.
• "SET DF" When this is displayed
the SELECT key must be pushed
and held until the "DONE"
prompt. Meter then returns to
"SPEC" branch heading.
• "GET DF" When this is displayed
the SELECT key must be pushed
and held until the "DONE"
prompt. This takes approximately