Avaya POLYCOM 8400-SES - Manual (Page 5)

CRK; Reviewed:
SPOC 7/1/2011 Solution & Interoperability Test Lab Application Notes
©2011 Avaya Inc. All Rights Reserved.
5 of 21
Polycom8400-SES
4. Equipment and Software Validated
The following equipment and software were used for the test configuration.
Equipment Software/Firmware
Avaya S87020 Servers Avaya Aura® Communication
Manager 5.2.1 (R015x.02.1.016.4)
Avaya G650 Media Gateway -
TN2312BP IP Server Interface
TN799DP C-LAN Interface
TN2302AP IP Media Processor HW11 FW044
HW01 FW028
HW20 FW118
Avaya Aura® SIP Enablement Services SES-5.2.1.0-016.4
Avaya S8300D Media Server with Avaya G450
Media Gateway Avaya Aura® Communication
Manager 6.0.1 (R016x.00.1.510.1) with
SP2 (00.1.510.1-18860)
Avaya 4600 and 9600 Series SIP Telephones
9620 (SIP)
9630 (SIP)
9650 (SIP) 2.6.4
2.6.4
2.6.4
Avaya 4600 and 9600 Series H.323 Telephones
4625 (H.323)
9620 (H.323)
9630 (H.323)
9650 (H.323) 2.9
3.1
3.1
3.1
Avaya 6408D+ Digital Telephone -
SpectraLink 8400 Series UCS 4.0.0.10555
5. Configure the Avaya Aura® Communication Manager
This section describes the procedure for setting up a SIP trunk between Communication Manager
and SIP Enablement Services. The steps include setting up an IP codec set, an IP network region,
IP node name, a signaling group, a trunk group, and a SIP station. Before a trunk can be
configured, it is necessary to verify if there is enough capacity to setup an additional trunk. The
highlights in the following screens indicate the values used during the compliance test. Default
values may be used for all other fields.
These steps are performed from the Communication Manager System Access Terminal (SAT)
interface. SpectraLink 8400 Series and other SIP telephones are configured as off-PBX
telephones in Communication Manager.