Configure ip node name, Configure sip signaling – Avaya POLYCOM 8400-SES User Manual
Page 9
CRK; Reviewed:
SPOC 7/1/2011
Solution & Interoperability Test Lab Application Notes
©2011 Avaya Inc. All Rights Reserved.
9 of 21
Polycom8400-SES
change ip-network-region 1 Page 1 of 19
IP NETWORK REGION
Region: 1
Location: Authoritative Domain: avaya.com
Name:
MEDIA PARAMETERS Intra-region IP-IP Direct Audio: yes
Codec Set: 1 Inter-region IP-IP Direct Audio: yes
UDP Port Min: 2048 IP Audio Hairpinning? n
UDP Port Max: 3029
DIFFSERV/TOS PARAMETERS RTCP Reporting Enabled? y
Call Control PHB Value: 46 RTCP MONITOR SERVER PARAMETERS
Audio PHB Value: 46 Use Default Server Parameters? y
Video PHB Value: 26
802.1P/Q PARAMETERS
Call Control 802.1p Priority: 6
Audio 802.1p Priority: 6
Video 802.1p Priority: 5 AUDIO RESOURCE RESERVATION PARAMETERS
H.323 IP ENDPOINTS RSVP Enabled? n
H.323 Link Bounce Recovery? y
Idle Traffic Interval (sec): 20
Keep-Alive Interval (sec): 5
Keep-Alive Count: 5
5.4. Configure IP Node Name
This section describes the steps for setting IP node name for SIP Enablement Services in
Communication Manager. Enter the change node-names ip command, and add a node name for
SIP Enablement Services along with its IP address.
change node-names ip Page 1 of 2
IP NODE NAMES
Name IP Address
ASM 10.64.40.42
CLAN 10.64.40.24
CLAN-AES 10.64.40.25
G450 10.64.41.21
MEDPRO 10.64.40.26
MM-MAS 10.64.20.63
S8300 10.64.42.21
SES 10.64.40.41
5.5. Configure SIP Signaling
This section describes the steps for administering a signaling group in Communication Manager
for communication between Communication Manager and SIP Enablement Services. Enter the
add signaling-group <s> command, where s is an available signaling group and configure the
following:
Group Type – Set to sip.
Near-end Node Name - Set to CLAN as displayed in Section 5.4.
Far-end Node Name - Set to the SIP Enablement Services name configured in Section
5.4.
Far-end Network Region - Set to the region configured in Section 5.3.
Far-end Domain - Set to avaya.com. This should match the SIP Domain value in
Section 6.1.