PATLITE BSV - Manual (Page 22)

- 22 -
8-2-2 MP3 Data
There are two ways to rewrite MP3 data. Please refer to the following considerations when selecting the creation
method for data.
1. When using the application software
Uses the application software to create a playlist file, then creates a playlist file to run with the MP3 data.
2. When not using the application software
A file can be created out of the MP3 data without the application software. A maximum of 15 selections can be set
up.
Please refer to the following table for the difference between the two methods when considering whether the application
software will be used.
Table1 Comparison Chart for the PATLITE Playlist Editor vs. MP3 Data application
Refer to the following diagram and examples on how to create the MP3 data file
Example 1�
003.mp3 -- MP3 data which can be assigned to message No.3
Example 2�
013.mp3 -- MP3 data which can be assigned to message No.13
* The file names can use both capital and small letters.
Item When to use it When not to use it
Every MP3 data message is played
A maximum of 1� selections can be
set up (It is combined freely and can
playback in order�
Only one selection can be set up
Individual MP3 data settings are made The volume, interval and number of
times repeated can be designated. Setup is not possible
003.mp3
Enter the message number in three digits from the range of 001 to 015