PATLITE BSV User Manual
Page 24
- 24 -
(1� Place the product into its standby condition (having no playback or signal inputs�.
(2� Insert the SD card with the rewritten and saved data into the SD card slot.
Refer to pg. 21 “8-2. SD Card Operation” for rewriting and saving the data.
(3� Rewriting will start when the SD card is inserted into the SD card slot.
- When rewriting starts, a short beep sound will be heard to indicate rewriting has started. When a long beep
sound is heard, it indicates the rewriting sequence is complete and the SD Card can be removed from the slot,
and when there is an error, the alarm will sound in combination with the contents of the error.
(Refer to pg. 25 “9. Error Table”)
- The data rewriting procedure should take a maximum of �0 seconds.
- If the power is turned off, or the SD card is extracted during data rewriting, the rewriting procedure will not be
completed. In this case, please start over to rewrite again.
- When rewriting, all previous saved MP3 data will be erased.
(4� After the MP3 data rewrite sequence has been completed, check that the data has been rewritten properly.
- When MP3 data playback is not normal
Please create data after formatting the SD card for FAT1�.
Please check whether any MP3 tags are attached. A tag may cause playback malfunctions.
8-2-4 Rewriting procedure for setting MP3 data and Operation Mode
[Formatting the SD card]
Please open the “My Computer” file in the personal computer, right-click the drive containing the SD card, and
choose “format.” The type of format used should be either FAT or FAT16.
* Caution: The execution of a format will eliminate all the data in the SD Card.
The optional SDV-128P type should be used for the SD card. The use of other SD Cards is not guaranteed by
PATLITE.
Format the SD card using the FAT1� protocol. The SD card cannot be recognized if it is formatted in any form
other than FAT1�.
Please
Note
When the slide switch is in the position
indicated in the drawing to the right, it is in
the protect condition. Move the swith in the
direction of the arrows to change from “Protect”
to “Release”
Protect
Release