PATLITE WDR-LE User Manual
Page 15
15
Wireless Data Communication System Supplementary Operation Manual [8167-C]
5
Select the [Other] tab, then select the type of
mode from the drop-down list
➡ To generate the same log output as the WDS-AE, the
"Signal Tower Information Output" box should be
enabled.
➡ Polling Mode: The transmitter mode is set for the "Polling Mode", to monitor the status at set intervals and
generate a CSV output from the application side when an event occurs.
➡ Event Mode: The transmitter mode is set for the "Event Mode", and generates a CSV output directly from the
transmitter when a change in status event occurs.
6
Click the [OK] button
➡ After clicking the [OK] button for the mode setting,
click the [OK] button when the message "To put the
changed settings into effect, close this application
and re-start it again."
7
Double Click the WDS-AUTO2 again
➡ When the application is started, an automatic
connection with a receiver is established, and the
network is started.
➡ When the network is properly set-up, the receiver/
transmitter will be displayed in the WD list window.
➡ As part of the application, the status log is also saved
as a CSV file.
Select
Click
Click