PATLITE WDR-LE - Manual (Page 17)

17
Wireless Data Communication System Supplementary Operation Manual [8167-C]
4 Set up the IP address and its port
➡ Be sure to click the "Enable" checkbox to activate the
LAN Port.
➡ In the definition file, the number of receivers
set up is displayed. After setting up the IP
Address and port number for the receiver
connections, place a checkmark in the box to
enable it.
➡ Enter a Username if necessary.
(Up to ten full-width characters)
Note
● The table below indicates Port Number and IP Address parameters that are out of bounds and cannot be set up.
Limited IP Address Range Description
127.0.0.0/8 All addresses that begin with 127
x.x.x.0 Network Address
x.x.x.255 Broadcast Address
Limited Port Number Description
Outside 1024-65535 All ports outside the range indicated
●
If a value outside the specified range is entered, an error will occur
and data entry will be disabled until a valid entry is entered.
5 Select the [Other] tab, then select the type of
mode from the drop-down list
➡ To generate the same log output as the WDS-AE, the
"Signal Tower Information Output" box should be
enabled.
➡ Polling Mode: The transmitter mode is set for the "Polling Mode", to monitor the status at set intervals and
generate a CSV output from the application side when an event occurs.
➡ Event Mode: The transmitter mode is set for the "Event Mode", and generates a CSV output directly from the
transmitter when a change in status event occurs.
(1) Set
(3) Click
(2) Set
Select