Sterlco SLS Series Light Duty Shredder - Manual (Page 32)

GRN4-600 Chapter 5: Maintenance 32 of 50
Dismounting the cutters
Follow the steps below to dismount the cutters. (See image below.)
1. Switch OFF the shredder at the main switch.
2. Safeguard the main switch with a padlock.
3. Open the lower housing panel.
4. Safeguard the housing panel.
5. Remove the screen.
6. Clean the hexagon head socket of the cutter mounting bolt (2).
7. Loosen the bolt using a high quality Allen key (.4 in. /10 mm). Lightly knock the
Allen key with a hammer to loosen if necessary.
8. Take out the cutter mounting bolt, the washer, and the cutter.
NOTE: It is possible to reach the cutting shaft by climbing into the feeding chamber;
however, it is strongly recommended that the cutters are accessed through the front
size door. The shaft can be rotated manually by turning the motor V-belt pulley.
Sharp knives are dangerous when while the rotor is at standstill.
Serious injury can result—especially to the hands and fingers—wear
protective gloves!
4
1
2
3
(1) Cutter
(2) Cutter mounting screw
(3) Cutter holder
(4) Cutter mounting
screws