Transmille 1000-Series - Manual (Page 85)

1000 SERIES OPERATION MANUAL
TRANSMILLE LTD. Version 1.30 Page 85
Simulated Resistance Commands
Function Mode Activation Command
Simulated Resistance I2
Range Command Output
0 Ohms – 10.0 Ohms R26 Ohms
10 Ohms – 50 Ohms R53 Ohms
50 Ohms – 100 Ohms R27 Ohms
100 Ohms – 1k Ohms R28 kOhms
1kOhms – 9.99kOhms R29 kOhms
10kOhms – 99.9kOhms R30 kOhms
100kOhms – 999kOhms R31 MOhms
1MOhms – 9.99MOhms R32 MOhms
Standby Mode
Standby ON S1
Standby OFF S0
Output
Set Output x.xxxx
The resistance section consists of a set of range commands which are used in
conjunction with the standby command. To enable a resistance to be set, the
following command sequence should be used :
<FUNCTION>/<RANGE>/<OUTPUT>/<STANDBY CONDITION><CR>
Examples :
8 kOhms 5 MOhms 60 Ohms
I2/R29/O8/S0<CR> I2/R33/O5/S0<CR> I2/R53/O60/S0<CR>
I2 = Simulated Resistance Function
R29 = 1kOhms – 9.99kOhms Range
O8 = 8 kohms Output
S0 = Standby OFF (i.e. output ON)
<CR> = Carriage Return (ASCII 13)
I2 = Simulated Resistance Function
R32 = 1MOhms – 9.99 MOhms Range
O5 = 5 MOhms Output
S0 = Standby OFF (i.e. output ON)
<CR> = Carriage Return (ASCII 13)
I2 = Simulated Resistance Function
R53 = 50 Ohms – 99.9 Ohms Range
O60 = 60 Ohms Output
S0 = Standby OFF (i.e. output ON)
<CR> = Carriage Return (ASCII 13)