UEi Test Instruments C75OILKIT - Manual (Page 7)

C75-MAN P. 6
SERVICE
1. The service mode is used for repair and calibration, and
should only be entered
by authorized service facilities.
2. The firmware can be displayed by entering “2222” for
the code.
You may exit the menu at any time by rotating the selector to a
different position unless the final logical “ENTER” is pressed, no
changes are made.
Storing and Viewing Test Results
At any time during a test you may store the readings in one of the 1
memory positions. Press “HOLD” button for 2 seconds or more to
store a reading. The memory location will be displayed briefly after the
two beeps.
To review stored readings select “Mem” on the selector.
VIEW
1. Pressing “ENTER” will allow you to view stored readings.
2. Press “ “ or “ “ to select different memory positions.
Note: You may print this test at any time by pressing
“PRINT” for 2 seconds.
DEL ALL
1. Clears all values stored in memory - Confirm with “YES”
then “ENTER”.
Rotate selector to any other position to exit Memory mode.
Printing Information
Supplied as an accessory for the analyzer is an infrared thermal printer.
Read the manual supplied with the printer prior to operation.
Connection to the analyzer is detailed below:
• Infrared thermal printer - this does not require a cable to transmit
the data but uses an infrared (IR) link similar to a TV remote
control. The IR emitter is positioned on the top of the analyzer
and the bottom of the printer. Ensure they are pointing at each
other and within 3 feet, with no obstructions in the way. Data may
be lost if transmission is interrupted. Keep the analyzer pointing at
the printer until the printout has finished.
Moving Through the Menu
The options in the menu system are in the following sequence by
pressing the down arrow:
Note: The menu choices are selected using the text printed on the case
above the function keys. The three keys are “ “ increases, “ “
decrease and “ “ enter.
Set Time
1. Press “ENTER”.
2. Use the up and down keys to select the correct time.
3. Press “ENTER” to move to the next digit.
Note: Time is displayed in military format, example 7:00 pm
is 19:00.
Date
1. Press “ENTER”.
2. Use the up or down arrows to select the correct data.
3. Press “ENTER” to move to the next digit and then exit.
Note: Time is displayed in military format. For example 7:00 pm
is displayed 19:00.
C F
1. Press “ENTER”.
2. Select degrees displayed in Fahrenheit or Centigrade using the
up or down keys.
3. Press “ENTER” to save and exit.
CONTRAST
1. Press “ENTER”.
2. Select a value between 02 and 254 for desired contrast using
the up or down keys.
Note: Lower values result in a darker display.
LANGUAGE
1. Press “ENTER”.
2. Select the desired language using the up or down keys.
3. Press “ENTER” to save and exit.
Header
1. Press up or down and “ENTER” to select desired header.
2. 2 lines of up to 16 characters will appear on the printout.
3. After entering text for header use the up or down buttons to
select “EXIT”.
AUX
1. Line 1 or Line 2.
• Press “ENTER”
• Press “ “ or “ “ to scroll through options
• Press “ENTER” again to choose the displayed option
2. Exit.
• Select “EXIT“, and then press “ENTER” to return to
the menu