Anchor Industries NAV50-1204 - Manual (Page 16)

15
UNITS WITH (2) OR MORE MID BAYS
ADDITIONAL GUIDE BARS
CAN BE PURCHASED
1
2
3
MIDDLE BEAMS THAT ARE NOT A PART
OF AN END MODULE USE THE HINGED
BASEPLATE (FOR PIVOTING TO VERTICAL).
FIXED PLATES ARE STAMPED “END” AND
SHOULD BE USED ONLY ON END MODULES.
X-CABLED BAYS
NAVI-TRAC UNITS 100 FT OR MORE IN LENGTH
MUST HAVE AN X-CABLED BAY NEAR THE MIDDLE
OF THE UNIT AND/OR EQUALLY SPACED) FOR
EVERY 100 FT UNIT OF LENGTH.
X-CABLING FROM EAVE TO BASE-
PLATE (AS SHOWN) ON BOTH
SIDES OF THE STRUCTURE
15-T
15-B
IN UNITS WITH MULTIPLE MIDDLE BAYS, THE SEC-
OND HIP END MODULE CAN BE ASSEMBLED AT
THE SAME TIME AS THE FIRST (OR LATER AFTER
THE MIDDLE BEAMS HAVE BEEN INSTALLED).
FOR MOST EASE, MAKE CONNECTIONS
IN THE ORDER SHOWN IN EACH BAY.
WHEN FRAME IS COMPLETE, MID
PANELS ARE INSTALLED THE SAME AS
PREVIOUSLY SHOWN IN THE SINGLE
MID BAY CONFIGURATION.
5
4
STAKE PLATES AT PROPER SPACING BEFORE
INSTALLING THE X-CABLES. THEN, ADJUST
TURNBUCKLES UNTIL CABLE IS SNUG
SUBSTITUTE BOLTS FOR PINS AT THE TOP
OF BOTH UPRIGHTS. THREADS SHOULD
POINT INWARD TOWARD EACH OTHER.
THREAD CABLE EYE NUTS ONTO EACH
BOLT TO SECURE THE CABLE.
REMOVE NUTS FROM THE BOLTS THAT PIN
THE BASEPLATE TO THE UPRIGHT. TURN
BOLTS SO THE THREADS ARE TO THE INSIDE
(FACING EACH OTHER). THREAD CABLE EYE
NUTS ONTO BOLTS TO SECURE THE CABLE.