Brother MFC-5890CN - Manual (Page 104)

Control panel setup
94
6
Ethernet (wired network only)
6
Ethernet link mode. Auto allows the print server to operate in 100BaseTX full or half duplex, or in 10BaseT
full or half duplex mode by auto negotiation.
You can fix the server link mode to 100BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and
10BASE-T Full Duplex (10B-FD) or Half Duplex (10B-HD). This change is valid after the print server has been
reset (default is Auto).
Note
If you incorrectly set this value, you may not be able to communicate with your print server.
a
Press Menu.
b
Press a or b to choose Network.
Press OK.
c
Press a or b to choose Wired LAN.
Press OK.
d Press a or b to choose Ethernet.
Press OK.
e Press d or c to choose Auto/100B-FD/100B-HD/10B-FD/10B-HD.
Press OK.
f Press Stop/Exit.
For Touchscreen models
6
a
Press MENU.
b Press Network.
c Press Wired LAN.
d Press Ethernet.
e Press Auto/100B-FD/100B-HD/10B-FD/10B-HD.
f Press Stop/Exit.