Using arp to configure the ip address, Ausing arp to configure the ip address – Brother MFC-5890CN User Manual

Page 177

Advertising
background image

Appendix A

167

A

Using ARP to configure the IP address

A

If you are unable to use the BRAdmin application and your network does not use a DHCP server, you can
also use the ARP command. The ARP command is available on Windows

®

systems that have TCP/IP

installed as well as UNIX

®

systems. To use arp enter the following command at the command prompt:

arp -s ipaddress ethernetaddress
Where ethernetaddress is the Ethernet address (MAC address) of the print server and ipaddress is the

IP address of the print server. For example:

„

Windows

®

systems

Windows

®

systems require the dash “-” character between each digit of the Ethernet address.

arp -s 192.168.1.2 00-80-77-31-01-07

„

UNIX

®

/Linux

®

systems

Typically, UNIX

®

and Linux

®

systems require the colon “:” character between each digit of the Ethernet

address.

arp -s 192.168.1.2 00:80:77:31:01:07

Note

You must be on the same Ethernet segment (that is, there cannot be a router between the print server and
operating system) to use the arp -s command.
If there is a router, you may use BOOTP or other methods described in this chapter to enter the IP
address.If your Administrator has configured the system to deliver IP addresses using BOOTP, DHCP or
RARP your Brother print server can receive an IP address from any one of these IP address allocation
systems. In which case, you will not need to use the ARP command. The ARP command only works once.
For security reasons, once you have successfully configured the IP address of a Brother print server using
the ARP command, you cannot use the ARP command again to change the address. The print server will
ignore any attempts to do this. If you wish to change the IP address again, use TELNET (using the SET
IP ADDRESS command) or factory reset the print server (which will then allow you to use the ARP
command again).
To configure the print server and to verify the connection, enter the following command ping ipaddress

where ipaddress is the IP address of the print server. For example, ping 192.189.207.2.

Advertising
This manual is related to the following products: