Brother MFC-5890CN - Manual (Page 92)

Control panel setup
82
6
Node Name
6
You can register the machine name on the Network. This name is often referred to as a NetBIOS name; it will
be the name that is registered by the WINS server on your network. Brother recommends the name
BRNxxxxxxxxxxxx for a wired network or BRWxxxxxxxxxxxx for a wireless network (where xxxxxxxxxxxx is
your machine’s Ethernet address) (up to 15 characters).
a
Press Menu.
b
Press a or b to choose Network.
Press OK.
c (For Wired) Press a or b to choose Wired LAN.
(For Wireless) Press a or b to choose WLAN.
Press OK.
d
Press a or b to choose TCP/IP.
Press OK.
e
Press a or b to choose Node Name.
Press OK.
f Enter the Node Name.
Press OK.
Note
DCP models cannot change the Node Name from the control panel menu.
g
Press Stop/Exit.
For MFC-5490CN
6
a Press Menu, 5, 1, 5.
b Select 1 to change. Enter the Node Name.
Press OK.
c Press Stop/Exit.
For Touchscreen models
6
a Press MENU.
b Press Network.
c
(For Wired) Press Wired LAN.
(For Wireless) Press WLAN.
d Press TCP/IP.
e
Press a or b to display Node Name and then press Node Name.
f Enter the Node Name.
Press OK.
g
Press Stop/Exit.