ADC Campus-RS Remote - Manual (Page 11)

152-402-145-02, Issue 2 Installation
H2TU-R-402 June 16, 2000 5
I
NSTALLATION
Figure 2. Installing the H2TU-R-402 List 4E
1 Check the setting of the SCURR switch. The default setting is disabled (up position). If the H2TU-R is locally
powered, and your application requires sealing current, place the SCURR switch in the down position.
2 Align the H2TU-R with the enclosure slot guides and slide the unit in. Push the unit back until it touches the
backplane card-edge connector.
3 Place your thumbs on the front panel and push the H2TU-R into the card-edge connector.
Wear an antistatic wrist strap when installing the H2TU-R. Avoid touching components on the
circuit board.
H2TU-R-402
Remote enclosure
SO LITA IRE
ALM
L
LO OP
ES F SF
B8Z S AM I
LB K
H
D
S
L
2
D
S
1
IN BR G OU T
RS -23 2 DC E
SCURR
SCURR SWITCH