Brother MFC 9840CDW - Manual (Page 101)

Making copies
85
12
Tray selection
12
You can change the tray use only for the next
copy.
a
Make sure you are in Copy mode .
b
Load your document.
c
Use the dial pad to enter the number of
copies (up to 99).
d
Press Tray Select.
e
Press d or c to choose the MP>T1,
T1>MP, #1(XXX)
1
or MP(XXX)
1
.
Press OK.
f
Press Black Start or Color Start.
1 XXX is the paper size you set in Menu, 1, 3.
Note
• T2 or #2 appears only if the optional paper
tray is installed.
• To change the default setting for Tray
Select, see Tray use in copy
mode on page 23.
Out of memory
message
12
If the memory becomes full while you are
making copies, the LCD message will guide
you through the next step.
If you get an Out of Memory message
while scanning a subsequent page, you will
have the option to press Black Start or
Color Start to copy the pages scanned so
far, or to press Stop/Exit to cancel the
operation.
To gain extra memory, you can do the
following:
„ Print the faxes that are in the memory.
(See Printing a fax from the
memory on page 49.)
„ You can turn off Fax Storage. (See
Turning off remote fax
options on page 68.)
„ Add optional memory (See Memory
board on page 112.)
Note
When you get an Out of Memory
message, you may be able to make
copies if you first print incoming faxes in
the memory to restore the memory to
100%.
Press Tray Select MP>T1 or M>T1>T2
T1>MP or T1>T2>M
#1(XXX)
1
#2(XXX)
1
MP(XXX)
1