Brother MFC-9130CW - Manual (Page 50)

Control panel setup
44
4
Fax to Server (MFC-9130CW, MFC-9140CDN, MFC-9330CDW and
MFC-9340CDW: available as a download)
4
The Fax to Server feature allows the machine to scan a document and send it over the network to a separate
fax server. The document will then be sent from the server as fax data to the destination fax number over
standard phone lines. When the Fax to Server feature is set to
On , all automatic fax transmissions from the
machine will be sent to the fax server for fax transmission. You can also continue to send a fax directly from
the machine using the manual fax feature.
To send a document to the fax server, the correct syntax for that server must be used. The destination fax
number must be sent with a prefix and a suffix that match the parameters used by the fax server. In most
cases, the syntax for the prefix is “fax=” and the syntax for the suffix would be the domain name of the fax
server E-mail gateway. The suffix must also include the “@” symbol at the beginning of the suffix. The prefix
and the suffix information must be stored in the machine before you can use the Fax to Server function.
Destination fax numbers can be saved in the Speed Dial locations or entered using the dial pad (up to 20 digit
numbers). For example, if you wanted to send a document to a destination fax number of 123-555-0001, use
the following syntax:
NOTE
Your fax server application must support an E-mail gateway.