Brother FAX-2440C - Manual (Page 96)

REMOTE FAX OPTIONS 6 - 8
95 Change the Fax
Forwarding, Paging or Fax
Storage settings
1 OFF You can select Off after you have retrieved
or erased all your messages.
2 Fax Forwarding If you hear one long beep, the change has
been accepted. If you hear three short beeps,
you cannot change it because something has
not been set up (for example, perhaps a Fax
Forwarding or paging number had not been
registered). You can register your Fax
Forwarding number by entering 4. (See
Changing your Fax Forwarding number on
page 6-9.) Once you have registered the
number, Fax Forwarding will work.
You can select Off after you have retrieved
or erased all your messages.
3 Paging
4 Fax Forwarding number
6 Fax Storage
96 Retrieve a fax
2 Retrieve all faxes Enter the number of a remote fax machine to
receive stored fax message(s). (See page
6-9.)
3 Erase faxes from the
memory
If you hear one long beep, fax messages
have been erased from the memory.
97 Check the receiving status You can check whether your machine has
received any fax or voice messages. If yes,
you will hear one long beep. If no, you will
hear three short beeps.
1 Fax
2 Voice
98 Change the Receive Mode If you hear one long beep, your change has
been accepted.
1 Msg Ctr
2 Fax/Tel
3 Fax Only
90 Exit Pressing 90 will allow you to exit Remote
Retrieval. Wait for the long beep, then replace
the handset.
Remote commands Operation details