Canon VIXIA HF G30 - Manual (Page 151)

Appendix: Menu Options Lists
151
[OLED Mirror Image]: When set to [i On], this function reverses the image on the screen horizontally
when you rotate the OLED panel 180 degrees toward the subject. In other words, the screen will show
a mirror image of the subject.
[OLED Color Balance]: Allows you to adjust the color balance of the OLED screen. Adjust the [B] (blue)
and [R] (red) bars by touching [+] and [-]. You can check the results on the screen.
[VF Brightness]: Sets the viewfinder screen to one of two brightness levels. You can use this to make
the screen brighter if it is difficult to see.
[Notification Sounds]: A beep will accompany some of the camcorder's operations.
• While pre-recording (A 88) is activated, the camcorder will not emit any notification sounds.
[Wireless Remote Control]: Allows the camcorder to be operated with the wireless controller.
[Powered IS Button]: Determines the operation mode of the assignable button set to [È Powered IS]
(A 61).
[Î Press and Hold]: Powered IS will be activated while you hold the button pressed down.
[Ï Toggle On/Off]: Each press of the button will turn the Powered IS function on and off.
[Set WB Priority]: You can press an assignable button set to [Ä WB Priority] to switch between the
current white balance and the white balance setting selected for [Set WB Priority].
[Focus/Zoom Ring Direction]: Changes the direction the focus/zoom ring needs to be turned.
[Focus/Zoom Ring Response]: Selects the sensitivity of the response when operating the focus/zoom
ring.
[Focus Preset Speed]: Determines the speed at which the focus changes to the preset position.
[Auto Power Off]: In order to save power when the camcorder is powered by a battery pack, it will
automatically shut off if left without any operation for 5 minutes.
• Approximately 30 seconds before the camcorder shuts off, [Auto Power Off] will appear.
[Battery Info]: When you are using a battery pack that is compatible with Intelligent System, this option
displays a screen where you can verify the battery charge (as a percentage) and the remaining
recording time (
mode) or playback time ( mode).
• If the battery pack is exhausted, the battery information may not be displayed.
[HDMI Time Code]: When set to [i On], the HDMI signal output from the camcorder includes the
camcorder's time code.
[HDMI Status]: Displays a screen where you can verify the standard of the output signal from the HDMI
OUT terminal.
[Output Onscreen Displays]: When set to [i On], the camcorder’s onscreen displays will appear also
on the screen of a TV or monitor connected to the camcorder.
[Distance Units]: Selects the units to use for the focusing distance display while focusing manually. This
setting also affects units for GPS information when using the optional GP-E2 GPS Receiver.
[GPS Auto Time Setting] : When the optional GP-E2 GPS Receiver is attached to the camcorder, you
can have the camcorder automatically set the time based on the information acquired from GPS. For
more details, refer to Setting Time from GPS on the Camera in the receiver's instruction manual.
COP
Y