Canon PIXMA iP100 - Manual (Page 54)

50 Routine Maintenance
Cleaning Your Printer
This section describes the cleaning procedure that is needed to maintain your printer.
„ Wiping Off Dirt on the Printer
Be sure to use a soft cloth such as eyeglasses cleaning cloth and wipe off dirt on the surface
with it gently. Smooth out wrinkles on the cloth if necessary before cleaning.
„ Cleaning the Paper Feed Roller (Roller Cleaning)
Clean the Paper Feed Roller if paper is not fed properly. Cleaning the Paper Feed Roller will
wear the roller, so perform this only when necessary.
Caution
z Do not use tissue paper, paper towels, or similar materials for cleaning so as not to scratch the surface.
Paper tissue powders or fine threads may remain inside the printer and cause problems such as Print
Head blockage and poor printing results. Make sure to use a soft cloth.
z Never use volatile liquids such as thinners, benzene, acetone, or any other chemical cleaner to clean
the printer, as this may cause a malfunction or damage the printer’s surface.
Caution
z Be sure to turn off the power and disconnect the power plug before cleaning the printer.
z Do not use tissue paper, rough-textured cloth, or similar materials, as this may scratch the
surface.
Note
Cleaning the Paper Feed Roller Without a Computer
The Roller Cleaning can also be performed without a computer, using the RESUME/CANCEL
button.
1. Make sure that the printer is on, and then remove any paper from the Rear Tray.
2. Hold down the RESUME/CANCEL button until the Power lamp flashes green three
times, and then release it immediately.
The Paper Feed Roller will rotate as they clean. The Power lamp is flashing green
while the Paper Feed Roller is rotating. The Power lamp is lit green when the Paper
Feed Roller finishes rotating.
3. Repeat step 2 twice.
4. Make sure that the Paper Feed Roller stops rotating, then load three or more sheets of
A4 or Letter-sized plain paper in portrait orientation in the Rear Tray.
The roller cleaning requires three sheets of A4 or Letter-sized plain paper.
5. Set the Paper Thickness Lever to the right. For details on the Paper Thickness Lever,
refer to “Front View” in “Main Components” of the User’s Guide on-screen manual.
6. Hold down the RESUME/CANCEL button until the Power lamp flashes green three
times, and then release it immediately.
The paper cleans the Paper Feed Roller as it feeds through the printer.
7. Repeat step 6 twice.
If the problem is not resolved, turn off the printer, unplug the power plug, and then
wipe the Paper Feed Roller located on the right side inside the Rear Tray with a
moistened cotton swab or the like. Rotate the roller manually as you clean it. Do not
touch the roller with your fingers; rotate it with the cotton swab. If this does not solve
the problem, contact your Canon Service representative.