Alpine DVA-9861 - Manual (Page 37)

35
-EN
When an external audio processor is connected to this unit, you can
operate it from this unit. Some audio processors may not be operated.
When PXA-H900 is connected, some of the operations may not be
performed from this unit. In this case, operate them in the connected
product. Explanations below is the case when PXA-H700 or PXA-H701
is connected for example.
Refer also to the operating instructions of the connected audio
processor.
• The adjustments or settings performed on the connected audio
processor cannot be operated properly from this unit.
• The setting "Setting the Speakers", "Setting Bass Sound Control",
and "Graphic Equalizer Adjustments" are not available if the MRA-
D550 is connected. Additionally, if the MRA-F350 is connected, the
following setting "Setting the MX mode" is not available. Also, the
setting content differs between the PXA-H700 and PXA-H701.
• This unit cannot be connected to the PXA-H510.
• If no operation is performed for approximately 15 seconds when
setting the external audio processor, the audio processor control
mode is canceled, and the normal mode returns.
Adjustment Procedure for Dolby
Surround
Make the adjustments described below in order to reproduce Dolby
Digital and DTS sound with greater accuracy.
Adjustment procedure
In case of combining the Automatic adjustments etc.
We recommend to make the Automatic adjustments before the Dolby
Surround adjustments.
External Audio
Processor
(Optional)
MUTE
Preset buttons
(1 through 6)
BAND Rotary encoder
MODE
1
2
3
4
5
6
7
Speaker Setup (page 40)
(Turning the speakers to be used on and off and
setting their response)
Adjusting the speaker levels (page 41)
(Adjusting the signal output level to the various
speakers)
Mixing bass sound to the rear channel
(page 41)
(Achieving smooth sound in the rear seat by mixing
the front audio signals with the rear speaker signals)
Adjusting the acoustic image (page 41)
(Adjusting the acoustic image to achieve a sound as
if the center speaker were directly in front of the
listener)
Achieving powerful high volume sound
(page 42)
(Achieving energetic sound with even greater power,
like the sound in a movie theatre)
Adjusting the DVD Level (page 42)
(Adjust the volume (signal level) in the Dolby Digital,
Pro Logic II, DTS and PCM modes.)
Storing Settings in the Memory (page 43)
(Storing all the settings and adjustments made on the
DVA-9861 (not only the above settings/adjusts) in the
memory)